This commercial project of the Booth’s Service Centre in North Gosford was worth $2.9M and extended over the course of 26 weeks, including design, management and building development stages. DURATION 26 weeks
Booths Service Centre Read More »
The project entailed the construction of new Primary School Building which is a combined 2 storey and single story building. The proposed buildings are comprised of new classrooms, amenities, services and associated plant areas. The ground floor is primarily made up off classrooms with amenities located at the Northern end of the 2 storey development,
Bishop Tyrrell Anglican College – New Primary School Building Read More »
The Avondale Retirement Village estate had regulatory commitments necessitating some demolition of existing buildings and construction of new aged care facilities. As a result, this project consisted of a new 122 bed aged care facility comprising 72 beds of high care, 35 low care beds and 15 special care beds across three levels of building.
Avondale Retirement Village Read More »
This Avondale Kressville aged care project was made up of four separate Buildings with four, two bedroom units to each building. The upper level units of the retirement facility have access from the road via a suspended concrete driveway. The lower units have driveways from the road that surrounds the project. North provided Avondale aged
Avondale Kressville Aged Care Read More »
This industrial project consisted of the construction of the new 11kV switch room was adjacent to the existing Avoca Zone power substation. Works included a new cable marshalling area below ground level with the switch and control rooms above at ground level. Conduits were installed between the existing “live” electricity substation and the new building
Avoca Zone Substation – 11kV switch room – Ausgrid Read More »
The Tanilba Bay Substation consisted of a new 11kv and 33kv switchrooms to upgrade the local area.. The construction consisted of insitu concrete basement slab and walls. The main structure was precast concrete wall panels and a kingspan roof planks. A new entry driveway and permiter fence to Ausgrid’s specifications. DURATION 32 weeks
Ausgrid Tanilba Bay Read More »
This Ourimbah power substation project involved the refurbishment of an existing oil containment bund at the Ourimbah substation. Transformers used throughout the electricity network are typically filled with oil to cool the transformer as required. If there is a leak, the oil is captured in the concrete bund and diverted to an oil seperator system
Ausgrid Substation Ourimbah – Transformer Bund Refurbishment Read More »
This project involved the installation of a full mechanical ventilation system into the existing Ausgrid power substation at Kooragang Island, Newcastle. The substation experiences a high heat load from the large amount of electrical equipment within the facility and excessive heat can reduce the efficiency of the substation. Further, the substation is in close proximity
Ausgrid Substation Kooragang Island – Air Conditioning Upgrade Read More »
The Kurri Kurri Substation project involved the construction of a new Switch building and outdoor switch yard, inclusive of an in-ground oil water separator tank and blast proof 400mm thick transformer walls with split face blocks. This substation was built to service the increasing demand for power in this area and as with all Ausgrid
Ausgrid Kurri Kurri Read More »
The Project was a three storey mixed use commercial real estate development consisting of contiguous piling, concrete slabs and columns and precast concrete panels for the external walls. The major challenges for this project were due to the constraints imposed by a tight building site, as this development was located in between two existing structures.
Aria – Building B (Terrigal Esplanade) Read More »